What NOT To Do Within The Peugeot 308 Key Fob Industry

· 4 min read
What NOT To Do Within The Peugeot 308 Key Fob Industry

Peugeot 308 Key Fob Replacement

Peugeot's 308 might be slightly old however it's still eye-catching. It's not the most luxurious car in its class but it's a Ford Focus or Volkswagen Golf will shield you from surface imperfections - but it's a relaxed and pleasant driving experience.

We often receive requests from Coded Car Keys to replace peugeot key fobs. The following tips can assist whether the issue is intermittent, or constant.

Water Damage

If you accidentally drop your key fob in the puddle, or it gets wet while kayaking canoeing, rafting, or canyoning the fob is more likely to be damaged by water. Keep your key fob in a dry container whenever you are outside or perform activities that expose it to a lot of water.

It's also crucial to ensure sure that the fob has dried before you open it and use it again. If you notice any odors emanating from the fob like an industrial liquid smell or windshield washer fluid, it's another sign that it's submerged in water.

A wet circuit can cause the battery's charge to drain or even explode. If you are able to get your 308 keyfob out of the water and turn it upside up and shake as much water as you can prior to opening the casing. Take the battery out, and then clean the circuit board using a cotton swab that has been dipped into 90-percent alcohol.

Other reasons your Peugeot 308 remote keyless entry system might not function include a dead battery for your coin or receiver module issue, signal interference, or an electronic chip that is defective. If none of these is the problem, you can try resetting your system by disconnecting the battery that is 12 volts for approximately 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with a remote-start feature that allows the driver to start the car from a distance, warming up or cooling down the vehicle prior to getting in. This feature is extremely beneficial particularly during the cold winter months. However, there are times when the remote start system ceases working due to a variety of reasons, like the battery in the coin is dead.

A coin-shaped battery found inside the key fob has a lifespan of between two and four years, based on how often used and the location where it was purchased. The date for use-by will be written on the packaging or mentioned in the user manual.

If the key fob is no longer working after being exposed water that is clean, remove the battery and clean the electronic chip with the help of a paper towel that has been soaked with isopropyl ethanol. Then dry the chip thoroughly before replacing it. In case of exposure to soapy or salty water, the chip might be fried and you will need to replace the key fob entirely.

If you're not certain the battery is faulty you can check the voltage with a multimeter set to your car's voltage range and connected to the plus and minus terminals.  peugeot 308 key replacement  should be around 12-13 volts, however, if it reads lower, the battery needs to be replaced. Alternatively, you can try to reset the on-board computer by disconnecting the 12 volt battery for a few minutes, and reconnecting it in reverse order (positive cable first followed by negative). The engine should be able to start after this.

Faulty Receiver Module

If you're unable to see the "Key Detected" message on your dashboard, then it's possible the receiver module has discovered a problem. It's the component that sends an alarm to the car when your key fob is activated, it also acts as an immobiliser. It also stops it from starting unless the correct key is present.



This could result from a variety of causes including water damage or simply ageing. If the chip inside your Peugeot 308 keyfob is damaged due to dirty tap water, it could be because the keyfob was exposed it. In this case you'll need to remove the unit apart and clean it thoroughly using isopropyl or electronic cleaner. Once it's dry you can put the battery back in and try it again.

If the issue is not resolved, it is recommended that you visit the local Peugeot expert or locksmith. They'll utilize a diagnostic tool to assist in identifying the problem and repair it for you.

It can be stressful to lose your Peugeot car key. However, a trained auto locksmith can address the problem in minutes. They can program your car and cut a new working key for you. Find a locksmith in your area.

Electronic chip malfunctions

The chip in the Peugeot 308 key fob plays a vital part in the remote control system. If the chip is damaged, you could be unable to start your car or receive a message stating "anti-theft". In this instance, the only solution is to replace the key. Fortunately, professional auto locksmiths can offer the service in the shortest amount of time.

The chip inside your Peugeot 308 key fob can fail due to sweat, water damage dirt, or any other cause. If your Peugeot key fob has been exposed to soapy or dirty water, it should be cleaned right away. You can clean the electronic component with the help of a towel that is soaked in isopropyl Alcohol. The battery should be allowed to fully dry.

Radio interference can cause the key fob to stop functioning. This could be caused by other devices that operate at the same frequency as your Peugeot key fob. This can be caused by problems with the environment or objects within the vicinity of the vehicle. It is recommended to see a Peugeot dealer if you encounter this issue.

The Peugeot Key Fob 207/308 is delicate and needs special care. You shouldn't drop it or throw it around. If you lose something, try to locate it as quickly as you can. You can reset the on-board computer by disconnection of the battery for a couple of minutes. Be sure to disconnect the negative cable first, and then the positive.